Ford 3000

Tractor has power steering and a front hydraulic lift blade

Work: Major Gas Engine Overhaul & Clutch Kit

Included in this overhaul:  Because these tractor engines are bored the block was over-bored to .020  and fit with new oversize pistons, rings, wrist pins. Also new wrist pin bushings.  Connecting rod's were fitted with new wrist pin bushings and resized to fit the new wrist pins..  Complete valve train includes new intake and exhaust valves, guides, springs and keepers.  Complete engine gasket set with crankshaft seals. New connecting rod and main bearings (not sure what size yet).  The flywheel needed to be milled and a rebuilt dual pressure plate kit installed. New throw-out bearing and pilot bearing.  Carburetor was rebuilt. New point's, condenser, rotor, cap, spark plugs and spark plug wires will be installed.  The vacuum advance on the distributor will be tested to be sure it works properly.  New water pump is standard on these engines along with a new engine oil pump.    Customer requested a new generator because the cost of a new one was less than rebuilding his old one.  The starter will be checked but it appears the starter is in good condition on this tractor.   This tractor has been well taken care of and after this overhaul it should give the owner many years of trouble free use.